Enable Telnet on Cisco AP

1> Go to exec mode:


2> You need to go to configuration mode:
AP#debug capwap console cli
This command is meant only for debugging/troubleshooting
Any configuration change may result in different
behavior from centralized configuration.

CAPWAP console CLI allow/disallow debugging is on
AP#config t

3> Configure AAA on AP:
aaa new-model
aaa authentication login vty0 local
aaa authorization exec vty0 local

4> Enable telnet on line vty:
line vty 0
authorization exec vty0
login authentication vty0
transport input telnet

This entry was posted in CISCO. Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s